BASEBANDS

        [NOEMAOFFLINE\]  BASEBANDS  [SelectionCode]  [/MODE [df1 [df2]]|OFF]
    [/RESET]

    After a receiver TUNING, select a number of 4GHz  basebands  and  assign
    them  a  correlator mode. Forthcoming SPW commands will concern only the
    selected basebands.  The selection is done  through  0  to  5  character
    codes  to  indicate  the band (2 characters), polarization, sideband and
    baseband (1 character each). Any of these elements  can  be  omitted  to
    make  no  particular selection on the corresponding, but if present, the
    above order must be preserved.

    Examples:
    BASEBAND        : will select all the basebands
    BASEBAND B1HUO  : will select only the outer baseband of the upper
                      sideband in polar H for the Band 1 tuning.
                      (Band is not mandatory when only 1 receiver band is tuned)

    The correlator mode selection is done using the /MODE option.