SET CALIBRATION

 

        LAS\SET CALIBRATION [Beam_Tol [Gain_Tol]] or OFF

    Specify the tolerance on the Beam efficiency (Beam_Tol) and  gain  image
    ratio  (Gain_Tol),  on turn or calibration checking.  A value of 0 means
    no check. The default values are 0.02 and 0 respectively.  These  values
    are  used by command SUM to verify that the calibration is coherent, and
    by command WRITE which  writes  the  corresponding  information  in  the
    output  file  only  if  Beam_Tol is non zero. Note that because the beam
    efficiency is less than 1, you could  use  Beam_Tol=1  to  suppress  the
    calibration checking but still write the information.